Show how an asynchronous counter with J-K flip-flops can be implemented having a modulus of. In Multisim I cannot get the numbers to display correctly and in Crocodile Clips there is only one number that displays. In synchronous counters, the clock input is connected to all. The full sequence doesn't show on all the 7-segment displays simultaneously like I need it to, instead it still shows the sequence as it counts from 2,1,0,6,5 up and down. The main problem I'm facing is that I cannot get the sequence to display. I'm not sure what to do to fix this problem. On Crocodile Clips only the '1' in the sequence displays and Multisim shows all the numbers but very incorrectly. SIMULATION OF THE CIRCUIT THROUGH MULTISIM from publication: A Novel Approach To Asynchronous State Machine Modeling On. I used a 5-bit ring counter using D flip-flops with a BJT transistor and 10k Ohm resistors to do this but the sequence doesn't display correctly on either of the two programs. Download scientific diagram 4-bit binary counter using J-K flip flops V. The problem comes when I need to display the entire sequence on the 7-segment displays. I used both Multisim and Crocodile Clips to simulate my design and it works fine. ![]() All four of the JK flip flops are hooked up to the same clock. I started first by designing the Up/Down counter and simulating it. The alarm wont turn off until the reset button is pressed (in this case, the push button. I was given a project to design a Synchronous Up/Down counter which displays my sequence (2,1,0,6,5) on 5 x 7-segment displays simultaneously.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |